Retention measurements (and measurements of hold-up volume and peak width) may be made in terms of times or chart distances as well as volumes. If flow and recorder speeds are constant, the volumes are directly proportional to the times and chart distances. The following definitions are drawn up in terms of volume, and it is recommended that theoretical discussion should be couched in the same terms wherever possible. The total retention volume, \(V_{\text{R}}\), is the volume of @E02040@ @C00863@ admitted to the column between the injection of the sample and the emergence of the peak maximum of the specified component. It includes the hold-up volume. In gas @C01075@, the volume of @C00863@ is specified at the outlet pressure and temperature of the column. Note: the word 'total' in this definition allows retention time to be used as a general term when specification of a particular quantity is not required. The adjusted retention volume, \(V_{\text{R}}^{'}\), is the total retention volume less the hold-up volume, \(V_{\text{M}}\), i.e. \[V_{\text{R}}^{'}=V_{\text{R}}- V_{\text{M}}=\overline{V}- V_{\text{I}}\] where \(\overline{V}\) is the peak @E02042@ volume and \(V_{\text{I}}\) the interstitial volume. The net retention volume, \(V_{\text{N}}\), is the adjusted retention volume multiplied by the pressure-@G02669@ correction factor: \[V_{\text{N}}=j\ V_{\text{R}}^{'}\] The specific retention volume, \(V_{\text{g}}\), is the net retention volume per @G02680@ of stationary liquid, @A00109@ or solvent-free @G02600@. In liquid @C01075@, except when conducted at very high pressures, the compression of the mobile phase is negligible, and the adjusted and net retention volumes are identical. The specific retention volume is then the adjusted retention volume per @G02680@ of stationary liquid, @A00109@, or solvent-free @G02600@. It is recommended that, when appropriate, authors specify the drying conditions. At \(0\ ^{\,\unicode{x26ac}}\text{C}\), \[V_{\text{g}}=273\ \frac{V_{\text{N}}}{w_{\text{L}}\ T}\] where \(w_{\text{L}}\) is the mass of the stationary liquid phase.